You can easily install a light in life jackets. Life jacket light is a safety light, so it is not necessary. It is optional equipment in life jackets.
If we want extra safety, we add life jacket lights on the life jacket to easily swim or travel in the water. It prevents us from drowning.
You can easily install the light in life jacket by following these steps:
1: Use a sharp implement and make a hole in the life jacket, which is 85mm deep.
2: Make a hole in the upper side of the life jacket.
3: Make sure that the light’s position in the life jacket is fitted correctly so that things in the water are easily visible to you.
4: Slowly press the housing assembly in the hole.
5: Put the light assembly into the housing.
6: Route the sensor is linked to the bottom of the lifejacket.
7: You make sure that during installation, you fit the sensor in such a way that when you are in the water, then this sensor is immersed in water.
8: The life jacket light switch is turned on automatically when the light is immersed in water.
After installation, you must check the sensor by dipping in water. If flash comes from light, then it is fitted correctly.
If you see any corrosion in light after a long time of usage, replace the battery unit with the new one to perform well and safe to use.
You can open the following link and easily understand how to install a life jacket light in the jacket.